Header sizing 914-6 |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Header sizing 914-6 |
mb911 |
Dec 27 2015, 02:21 PM
Post
#1
|
914 Guru Group: Members Posts: 6,851 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
So while my 914-6 oil tanks are being machined I going to start working through my header with heat exhanger design out of stainless.. I do not have non compete on these with m&k so that gives me design freedom.. However I will use similar design process as the m&k/ rarlyl8 design. So my question is 1.5" the most common size or allot of you using 1.625
|
mb911 |
Dec 31 2015, 02:40 PM
Post
#2
|
914 Guru Group: Members Posts: 6,851 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
Picked up the engine today thanks John. Going to build a 2x4 stand this week so I can put the engine and the trans on the stand upside down and can build the exhaust as if it were sitting on a bench.. .. Need confirmation that the bracket c is the same as bracket b except for the spacing on the muffler bolt holes..
|
Lo-Fi Version | Time is now: 16th May 2024 - 06:53 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |