Header sizing 914-6 |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Header sizing 914-6 |
mb911 |
Dec 27 2015, 02:21 PM
Post
#1
|
914 Guru Group: Members Posts: 6,851 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
So while my 914-6 oil tanks are being machined I going to start working through my header with heat exhanger design out of stainless.. I do not have non compete on these with m&k so that gives me design freedom.. However I will use similar design process as the m&k/ rarlyl8 design. So my question is 1.5" the most common size or allot of you using 1.625
|
jmill |
Dec 31 2015, 06:10 PM
Post
#2
|
Green Hornet Group: Members Posts: 2,449 Joined: 9-May 08 From: Racine, Wisconsin Member No.: 9,038 Region Association: Upper MidWest |
OK, I thought I had a couple of 2.0 muffler hangers I could give Ben. I don't. I must have gave them away or put them somewhere I wouldn't lose them. (IMG:style_emoticons/default/rolleyes.gif)
Ben needs some measurements. Can someone with a 2.0 muffler hanger give him the center to center measurements in the picture below. If a couple of guys pipe in and confirm them, even better. Attached image(s) |
Luke M |
Dec 31 2015, 06:16 PM
Post
#3
|
Senior Member Group: Members Posts: 1,372 Joined: 8-February 05 From: WNY Member No.: 3,574 Region Association: North East States |
OK, I thought I had a couple of 2.0 muffler hangers I could give Ben. I don't. I must have gave them away or put them somewhere I wouldn't lose them. (IMG:style_emoticons/default/rolleyes.gif) Ben needs some measurements. Can someone with a 2.0 muffler hanger give him the center to center measurements in the picture below. If a couple of guys pipe in and confirm them, even better. I have one off my 6. I'll go out and measure it in a few. 20" c to c on header flange mount, 5" c to c on trans mount holes, 6 1/4" c to c from trans mount down to center flange line. |
Lo-Fi Version | Time is now: 16th May 2024 - 06:37 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |