 Alignment Spec Questions, another alignment thread |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| John |
 Mar 15 2005, 03:38 PM
Post
#1
|
|
member? what's a member?  Group: Members Posts: 3,393 Joined: 30-January 04 From: Evansville, IN (SIRPCA) Member No.: 1,615 Region Association: None  |
I have a few questions that some of you smart people out there might be kind enough to answer for me.
I am wondering how you convert angular toe-in (per factory specs) to inches of toe-in. I could convert angles to inches if I knew where to measure. Is the toe-in measured at the rim, at the tread, at the sidewall? Or am I reading the chart from the factory manuals incorrectly? What are the "factory" settings for: Front Caster Front Camber Front Toe Rear Camber Rear Toe On another note, RIDE HEIGHT......... The front ride height is measured as the DIFFERENCE between the center of the torsion bar and the center of the wheel rim. How is the rear ride height supposed to be measured, and what is the 'spec'????? Thanks for replying. |
   |
 
|
Posts in this topic
JOHNMAN Alignment Spec Questions Mar 15 2005, 03:38 PM
Joe Ricard I guess it depends which car are you going to alig... Mar 15 2005, 07:12 PM Dave_Darling Stock camber is 0 degrees front, -1/2 degree rear.... Mar 15 2005, 08:02 PM JOHNMAN Thank you Joe and Dave for replying.
I was hoping... Mar 15 2005, 10:10 PM JOHNMAN My questions started this weekend when I aligned t... Mar 15 2005, 11:01 PM J P Stein Angular to Lineal must be calculated over a known ... Mar 16 2005, 12:33 AM JOHNMAN Thanks J P
But is it 15" or is it 7.5"??? Mar 16 2005, 12:40 AM J P Stein <... Mar 16 2005, 03:34 AM JOHNMAN I suppose that I have not been clear.
The camber ... Mar 16 2005, 05:14 PM Joe Ricard Yada Yada Yada. Holy crap you make my head hurt.
... Mar 16 2005, 07:08 PM J P Stein OK, If you measure from a line parallel to the cen... Mar 16 2005, 07:21 PM JOHNMAN Thanks again JP.
I did some searching and came to... Mar 18 2005, 01:12 AM Joe Ricard <... Mar 18 2005, 06:46 AM Dave_Darling <... Mar 18 2005, 05:12 PM J P Stein How low is tougher and is another double edged swo... Mar 18 2005, 11:33 PM
JOHNMAN Um, Dave,
This is a 914. I don't have torsi... Mar 19 2005, 10:12 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 11:37 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.