 Taco Plate - Which Way is Up |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Amphicar770 |
 Mar 28 2016, 12:48 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,191 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region 
 |
Hi all,
The following photo shows the direction that my taco plate is installed. The indent goes in toward the sump. I have seen pictures of other plates where it is installed the other way (indent out). What is correct? Thanks Mike  |
   |
 
|
  |
Replies(1 - 3)
| jcd914 |
Mar 28 2016, 01:43 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,081 Joined: 7-February 08 From: Sacramento, CA Member No.: 8,684 Region Association: Northern California |
You are missing the cover plate, it has a hump to cover the sensor.
When installed it could look like someone had sensor plate upside down. Jim |
|
|
|
| Amphicar770 |
Mar 28 2016, 03:03 PM
Post
#3
|
|
Senior Member Group: Members Posts: 1,191 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region
|
QUOTE(jcd914 @ Mar 28 2016, 03:43 PM)  You are missing the cover plate, it has a hump to cover the sensor. When installed it could look like someone had sensor plate upside down. Jim Thanks. I knew something did not look right. Just found the cover. Now I need to get a new gasket for it. Ugh. |
|
|
|
| TheCabinetmaker |
Mar 28 2016, 04:04 PM
Post
#4
|
|
I drive my car everyday Group: Members Posts: 8,300 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666 |
And new crush washers too.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 09:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.