 Clutch lever arm - how's this look |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Amphicar770 |
 Apr 30 2016, 08:11 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,188 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region 
 |
In addition to the one already there, I added a 2nd 1mm washer under the pivot ball.
With tranny mounted to engine, looks like about 1/2" on the engine side if throw out bearing is touching pressure plate. About an inch on the other side. Good or do I need another washer or thicker washer? Thx.  |
   |
 
|
Posts in this topic
Amphicar770 Clutch lever arm - how's this look Apr 30 2016, 08:11 PM
dangrouche If 2mm was removed from the face of the flywheel, ... Apr 30 2016, 08:47 PM Amphicar770 Unfortunately, I do not know how much was taken of... Apr 30 2016, 08:51 PM cuddyk I believe that 1/2" guideline in the pelican ... Apr 30 2016, 10:31 PM
Amphicar770
I believe that 1/2" guideline in the pelican... May 1 2016, 06:31 AM r_towle Interesting, I never measured it that way.
For me... May 1 2016, 02:32 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th May 2024 - 06:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.