 Vacuum stack elbow, 914rubber------HELP! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| brownaar |
 Jan 17 2017, 08:11 AM
Post
#1
|
|
Member  Group: Members Posts: 263 Joined: 23-September 04 From: Gate City, VA Member No.: 2,813 Region Association: None  |
Mark, any chance you'll make these at some point? Just received a new one from somewhere else and the quality............who am I kidding, there is no quality in the hunk I bought.
Thanks, Aaron  |
   |
 
|
  |
Replies
| Frankvw |
Jan 17 2017, 08:57 AM
Post
#2
|
|
working on my first 914 ! Group: Members Posts: 651 Joined: 13-April 16 From: Holland, the Netherlands Member No.: 19,896 Region Association: Europe |
Hi, I needed them as well, and I did order them at VW directly
see my post on this: http://www.914world.com/bbs2/index.php?sho...amp;hl=homemade I am not sure if they are the same as yours. I am also not sure how they suppose to look like, since I was missing it entirely (so I have no old one to compare to). I did install it, I do not recall it was a low quality.... |
|
|
|
Posts in this topic
brownaar Vacuum stack elbow Jan 17 2017, 08:11 AM
BillC I've been asking Mark to make those for over a... Jan 17 2017, 08:44 AM cary I've given him a couple samples. I also showed... Jan 17 2017, 09:18 AM Dave_Darling You realize you can make something functionally id... Jan 17 2017, 01:23 PM
BillC
You realize you can make something functionally i... Jan 17 2017, 01:40 PM
Dave_Darling It's not that easy, because of where it fits a... Jan 17 2017, 10:29 PM BillC Note--I am not saying that this is a replacement f... Jan 18 2017, 08:57 AM pbanders
You realize you can make something functionally i... Jan 17 2017, 11:31 PM Mikey914 Yes, it is on the list. I had to clean up some hea... Jan 17 2017, 02:28 PM Mikey914 Thanks,
Yes I will do these shortly. Jan 18 2017, 10:36 AM stinkindiesel Thanks for looking at this, Mark. Add me to the li... Jan 18 2017, 07:53 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 12:06 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.