|
|

|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| arne |
Mar 27 2017, 11:01 AM
Post
#1
|
|
Serial Rescuer of old vehicles... ![]() ![]() ![]() Group: Members Posts: 789 Joined: 31-January 17 From: Eugene, Oregon Member No.: 20,799 Region Association: None |
Well, as I posted at the end of my intro thread ( http://www.914world.com/bbs2/index.php?sho...=303932&hl= ), I bought my 914 over the weekend. We've all heard of barn and garage finds, this car was found in a large storage unit.
Details - '73 2.0, 4732924138, yellow. Rust seems limited to the battery tray, passenger floor and right sail panel (where water obviously got trapped behind the vinyl). The hell hole looks solid at this point. None of the rust appears to be holes yet. Definitely some work to do there. The car was said to run when it was parked in the unit, other people not involved in the sale confirmed that it drove in under its own power. Been sitting for 6 years or so. After it got in, the seller began very rudimentary prep for restoring it, but life got in the way. So about all that was done was to pull all the lenses off. I'm waiting for a flatbed to gather it up now, should have it in my garage later today. Here are a couple of pictures to show the beginning. |
arne '73 2.0, a yellow storage unit find Mar 27 2017, 11:01 AM
arne Looks Great!
Yes, and even better after clean... May 20 2017, 05:47 PM
arne Right side. Very nice as well.
May 20 2017, 06:09 PM
ConeDodger :woohoo: one of those oh thank goodness moments... May 20 2017, 07:31 PM
arne
:woohoo: one of those oh thank goodness moments... May 20 2017, 07:46 PM
arne Engine drop prep continues. Exhaust is out today.
... May 24 2017, 03:15 PM
mepstein
Engine drop prep continues. Exhaust is out today.... May 24 2017, 04:36 PM
euro911 I always remove the muffler before the heat exchan... May 24 2017, 04:56 PM
arne I will probably put them back on that way, but did... May 24 2017, 05:03 PM
arne Other observations -
The little thermostat bello... May 24 2017, 07:30 PM
euro911 Other observations -
The little thermostat bello... May 24 2017, 11:43 PM
mepstein The thermostat wire is a derailleur wire available... May 25 2017, 04:02 AM
arne
The thermostat wire is a derailleur wire availabl... May 25 2017, 08:29 AM
arne Engine down!
Thanks to the following, it was ... May 26 2017, 05:54 PM
cuddyk
Engine down!
Thanks to the following, it was... May 28 2017, 12:58 PM
mepstein Get 12mm copper plated exhaust nuts. They are easi... May 26 2017, 06:05 PM
Cevan
Get 12mm copper plated exhaust nuts. They are eas... Jun 27 2017, 10:46 AM
arne Roger that on the copper plated nuts, I've use... May 26 2017, 10:54 PM
arne More progress today. The clutch is fine, does not ... May 27 2017, 06:30 PM
porschetub
More progress today. The clutch is fine, does not... May 28 2017, 09:01 PM
cary Looks like a great car and gifted owner. I too (Ja... May 28 2017, 11:32 AM
arne
Looks like a great car and gifted owner. I too (J... May 28 2017, 01:09 PM
JRust Hey Arne your making great progress. I saw you wer... May 28 2017, 02:33 PM
euro911 Albay, OR ... PA ... or NY? :confused: May 28 2017, 02:41 PM
arne I did manage to find a good pedal board if you sti... May 28 2017, 08:16 PM
arne Spent time today compiling the parts I'll need... May 29 2017, 06:31 PM
mstein95 Arne -
Sorry haven't been available to assist... May 30 2017, 10:04 AM
arne
Arne -
Sorry haven't been available to assis... May 30 2017, 10:43 AM
arne I'm quite pleased with the hell hole situation... Jun 4 2017, 07:28 PM
mepstein An engine drop sounds scary but once you do it, it... Jun 4 2017, 08:03 PM
rhodyguy That doesn't look so bad. Consider pulling the... Jun 4 2017, 08:27 PM
arne Yeah, I was hoping I could avoid the drop because ... Jun 4 2017, 08:28 PM
arne I've had the pad down, in fact getting it prop... Jun 4 2017, 08:29 PM
arne Update - I was planning to put the engine back in ... Jun 5 2017, 11:59 AM
arne Today's tech tidbit - Yes, it is possible to c... Jun 5 2017, 06:26 PM
mepstein Personally, I think the engine pads on the engine ... Jun 5 2017, 07:47 PM
arne Cleaning various bits and making things nice, whil... Jun 7 2017, 09:21 AM
arne Well, I believe that most of the "have-to... Jun 8 2017, 04:39 PM
arne Have started gathering other parts that I will nee... Jun 10 2017, 12:20 PM
Calvinator2016
Have started gathering other parts that I will ne... Jun 10 2017, 12:49 PM
arne New complete pad from 914Rubber. Fantastic part. Jun 10 2017, 01:15 PM
Calvinator2016
New complete pad from 914Rubber. Fantastic part.
... Jun 10 2017, 02:02 PM
JRust If your interior Backpad isn't great. I have a... Jun 10 2017, 05:03 PM
arne Thanks, Jamie. The backpad in mine is pretty nice ... Jun 10 2017, 05:15 PM
arne Got the engine and transmission back into the car ... Jun 18 2017, 07:46 PM
arne Got to thinking about what's next. Need to han... Jun 18 2017, 09:31 PM
arne And it runs again. Hung the muffler, connected the... Jun 19 2017, 03:04 PM
JRust Nice Arne! Yeah I've got to snag the pedal... Jun 19 2017, 11:12 PM
arne Since the last post when I said it was running aga... Jun 22 2017, 09:30 PM
arne Got it! It runs again!
When dropping the ... Jun 23 2017, 03:29 PM
Calvinator2016
Got it! It runs again!
When dropping the... Jun 23 2017, 04:20 PM
euro911 Got it! It runs again!
When dropping the ... Jun 23 2017, 06:55 PM
arne
Got it! It runs again!
When dropping th... Jun 23 2017, 05:02 PM
arne Took it out for a short drive. It is running good,... Jun 23 2017, 07:01 PM
JRust I've got the pedal board in my truck now Arne.... Jun 23 2017, 07:31 PM
arne Yeah, I've replaced all the fuel lines, don... Jun 23 2017, 07:46 PM
arne Had the car out and about yesterday, a couple of t... Jun 27 2017, 09:45 AM
arne Speaking of things that don't work, it's r... Jun 27 2017, 10:14 AM
euro911 Speaking of things that don't work, it's r... Jun 27 2017, 04:40 PM
JRust
Speaking of things that don't work, it's ... Jun 27 2017, 10:10 PM
arne Thanks, Mark. I have dealt with the odo issue on p... Jun 27 2017, 04:56 PM
arne I'll send you a PM on the handle, Jamie. Not s... Jun 28 2017, 08:30 AM
euro911 Tim (timothy_nd28) is the gauge guru on this board... Jun 28 2017, 02:53 PM
arne Disassembly has begun. This appears to be a recurr... Jun 28 2017, 09:18 PM
arne More...
Jun 29 2017, 05:48 PM
euro911 That's precisely why one needs two of them ...... Jun 29 2017, 07:34 PM
arne
That's precisely why one needs two of them ..... Jun 29 2017, 07:56 PM
euro911 Nice. Just lifted my '66 up in the air this ... Jun 29 2017, 08:29 PM
arne Dropped off both front and rear deck lids to be ba... Jun 30 2017, 01:47 PM
arne Disassembly and paint prep continues. Aiming for m... Jul 7 2017, 04:27 PM
arne Front lid.
Jul 7 2017, 05:15 PM
Cairo94507 Nice lids for sure. Jul 7 2017, 05:34 PM
arne Pulled the final bits out yesterday, then had the ... Jul 10 2017, 06:02 PM
Calvinator2016
Pulled the final bits out yesterday, then had the... Jul 10 2017, 07:30 PM
euro911 Nice. You're making a lot better progress than... Jul 10 2017, 07:30 PM
arne Looks like you are going to drive it there. :dr... Jul 10 2017, 07:37 PM
Calvinator2016
Looks like you are going to drive it there. :d... Jul 10 2017, 07:51 PM
arne Agreed on both counts. It is progressing much fast... Jul 10 2017, 10:25 PM
arne Dropped it off with the painter today. Initial dis... Jul 11 2017, 06:06 PM
arne I've been on the road for a few days, but some... Jul 16 2017, 07:26 PM
arne No surprises so far...
Jul 26 2017, 01:30 PM
arne More progress. Should be back in my garage in a fe... Aug 1 2017, 12:30 PM
914 7T3 Outstanding!!!
:shades2: Aug 1 2017, 12:47 PM
JRust Nice! Looking good Arne Aug 1 2017, 12:56 PM
arne Finalized a good sized order with Scott at 914rub... Aug 1 2017, 02:06 PM
rgolia love that color....just a little biased of course ... Aug 1 2017, 04:02 PM
arne
love that color....just a little biased of course... Aug 1 2017, 04:52 PM
euro911 ... and a lot of little flying bugs :poke: Aug 1 2017, 05:12 PM
arne
... and a lot of little flying bugs :poke:
Oh yes... Aug 1 2017, 05:47 PM
arne Also have noted I still have a small oil drop from... Aug 1 2017, 06:07 PM
euro911 Also have noted I still have a small oil drop from... Aug 1 2017, 09:03 PM
porschetub Going really well ,you are going fast,nice solid c... Aug 1 2017, 06:12 PM
arne Racer Chris and I sponsored a group buy from Neil ... Aug 1 2017, 09:22 PM
euro911 Looks like the price has gone up a little in the p... Aug 1 2017, 10:20 PM
arne Out of the booth...
Aug 2 2017, 11:13 AM
arne And a big box from 914rubber arrived today. Carpet... Aug 2 2017, 08:58 PM
euro911 Your car looks great already :headbanger:
Wishe... Aug 2 2017, 09:45 PM
arne Brought it home from the paint shop today. Haven... Aug 7 2017, 01:58 PM![]() ![]() |
|
Lo-Fi Version | Time is now: 24th October 2025 - 07:29 PM |
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |