 Hard starting, low hunting idle, until it warms up? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Geezer914 |
 May 27 2017, 09:30 AM
Post
#1
|
|
Geezer914  Group: Members Posts: 1,427 Joined: 18-March 09 From: Salem, NJ Member No.: 10,179 Region Association: North East States 
 |
1975 1.8L Ljet injection. Car is hard to start. It takes 3-4 tries and some time a shot of starting fluid. Fuel pressure gauge reads 30 lbs. in engine compartment. The rpm rises to 1800 rpm for about 15 seconds, then the idle hunts between 500 rpm and almost stalling out. After the engine warms up it runs and starts as normal. Vacuum hoses are tight. Comments? (IMG:style_emoticons/default/confused24.gif)
|
   |
 
|
Posts in this topic
Geezer914 Hard starting, low hunting idle, until it warms up? May 27 2017, 09:30 AM
The Cabinetmaker Aar? May 27 2017, 09:36 AM Beebo Kanelle Gasoline filter will allow pressure to build, but ... May 27 2017, 09:50 AM Rob-O So much to test for, but in my opinion (and I just... May 27 2017, 12:31 PM The Cabinetmaker If the cht is unplugged, it goes full rich. Not hi... May 27 2017, 02:40 PM Geezer914 Checked the AAR regulator with an ohm meter and it... May 28 2017, 12:39 PM
timothy_nd28
Checked the AAR regulator with an ohm meter and i... May 31 2017, 01:34 PM jim_hoyland I've found the same condition on occasion too:... May 29 2017, 06:00 AM Geezer914 Installed new intake runner gaskets, intake hoses,... May 31 2017, 12:10 PM jim_hoyland
Installed new intake runner gaskets, intake hoses... May 31 2017, 12:38 PM Geezer914 Head temp spec is 2500 to 3000 when cold. Correct... May 31 2017, 05:10 PM timothy_nd28 280k ohms > 2.5-3.0k ohms, still out of spec. ... May 31 2017, 06:15 PM Geezer914 I checked the connection from the AFM to the dual ... Jun 1 2017, 05:44 AM Geezer914 Tested AFM:
pins 6 & 9 200-400 ohms 282
pi... Jun 1 2017, 06:42 AM timothy_nd28 I don't think there is anything majorly wrong ... Jun 1 2017, 10:22 AM Geezer914 Thanks everyone for taking the time to post replie... Jun 2 2017, 05:52 AM porschetub I don't usually comment on running faults with... Jun 2 2017, 02:43 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 10:52 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.