 hand throttle vs cold start circuit, Anyone use the CSC on Webers? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bbrock |
 Nov 13 2017, 03:50 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains 
 |
My Webers have the cold start circuits installed. While I'm replacing the floor pan and have easy access to the tunnel, I am thinking about adding a couple tubes to run cables from a hand throttle lever to the carbs to operate the chokes. Wondering if anyone has done this and whether it would provide superior cold starting to the traditional hand throttle. I live in the frigid north where it can freeze any day of the year, so I want the best cold start operation I can get. Thoughts?
|
   |
 
|
Posts in this topic
bbrock hand throttle vs cold start circuit Nov 13 2017, 03:50 PM
GeorgeRud The original hand throttle just provided another w... Nov 13 2017, 04:12 PM
bbrock
The original hand throttle just provided another ... Nov 13 2017, 04:40 PM porschetub No not really needed a handthrottle is a better so... Nov 13 2017, 05:32 PM DaveO90s4 My 914 as purchased with its single centre mounted... Nov 13 2017, 05:44 PM nditiz1 Mine did have the CSC hooked up on both carbs. I ... Nov 13 2017, 06:09 PM bbrock
No not really needed a handthrottle is a better s... Nov 13 2017, 06:45 PM theer I had a hard time starting my 1.9l w/ dual 40 webe... Nov 13 2017, 07:07 PM bbrock
So - do I have this circuit already, or is it an ... Nov 13 2017, 08:09 PM Tbrown4x4 None of my 40 IDF castings are not even machined f... Nov 13 2017, 07:07 PM Tbrown4x4 The IDF's don't have choke plates or a mec... Nov 13 2017, 07:10 PM Tbrown4x4 Most people disable them by tapping the casting fo... Nov 13 2017, 08:33 PM bbrock
Most people disable them by tapping the casting f... Nov 13 2017, 08:59 PM porschetub No its not really that cold in winter @ my part of... Nov 15 2017, 01:01 PM Spoke My 2056 has dual carbs and starting it is not too ... Nov 15 2017, 02:58 PM Tbrown4x4 My car doesn't sit very much, but I put a fuel... Nov 15 2017, 08:54 PM Elliot Cannon My fuel pump (CB Peformance 3.5psi) comes on as so... Nov 15 2017, 11:25 PM bbrock This is all great feedback. Still would love to h... Nov 16 2017, 01:12 PM jd74914
As for forgetting to put the lever down after the... Nov 16 2017, 01:31 PM bbrock
Ehh, really no different than a cold start value ... Nov 16 2017, 06:01 PM brant my current motor is FI
but I daily drove a 2.0/4 f... Nov 17 2017, 03:20 PM Mark Henry Cold start circuit I would disable, shit design. I... Nov 17 2017, 01:43 PM bbrock
Cold start circuit I would disable, shit design. ... Nov 17 2017, 03:00 PM Mark Henry Only time you would run into issues with the IDF w... Nov 17 2017, 05:05 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 01:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.