 torque setting calculations |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| JFG |
 Dec 2 2017, 02:39 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 686 Joined: 7-April 16 From: Wales Member No.: 19,869 Region Association: None  |
I've discovered that my torque wrench only goes up to 160 ft lbs. I need another 50 ft lbs to lock up the rear drive shafts into the wheel bearing hub.
I have an angle gauge and was wondering if it is possible to convert the remaining 50 ft lbs into degrees for the angle gauge? |
   |
 
|
Posts in this topic
JFG torque setting calculations Dec 2 2017, 02:39 AM
barefoot Don't think an angle gage would work as the # ... Dec 2 2017, 06:42 AM
Mark Henry
Don't think an angle gage would work as the #... Dec 2 2017, 08:53 AM JOEPROPER I'd buy another torque wrench if i were you. ... Dec 2 2017, 07:36 AM cuddyk I bought a high range torque wrench from HF for 65... Dec 2 2017, 08:06 AM Tbrown4x4 Borrow, rent, or buy the proper torque wrench. The... Dec 2 2017, 08:24 AM jd74914 :agree:
I always just stand the correct length o... Dec 2 2017, 08:57 AM Tbrown4x4 Sorry for the general, too detailed answer. Early ... Dec 2 2017, 10:30 AM JFG Thanks for the info. For now I have used my break... Dec 2 2017, 10:58 AM porschetub 3/4'' drive is the only way to go,I've... Dec 2 2017, 11:48 AM Mark Henry
3/4'' drive is the only way to go,I'v... Dec 3 2017, 07:32 AM Triaddave That is one of those things you check every time y... Dec 2 2017, 11:59 AM Elliot Cannon Buying a torque wrench from HF. Standing on a bre... Dec 2 2017, 12:04 PM stugray
Buying a torque wrench from HF. Standing on a br... Dec 2 2017, 01:45 PM Elliot Cannon
Buying a torque wrench from HF. Standing on a b... Dec 2 2017, 10:28 PM Dave_Darling
So, if you attached one of these to a 2 foot long... Dec 3 2017, 12:35 PM Andyrew Ive never torqued the stub axle. I use my cheater ... Dec 3 2017, 11:01 AM Mueller In the Machinist Handbook, page 1406 there is a me... Dec 3 2017, 02:02 PM Elliot Cannon Does the cleanliness of the threads affect the tor... Dec 3 2017, 02:31 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2024 - 03:10 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.