 door jamb air tube, braze or weld? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bbrock |
 Feb 7 2018, 10:48 AM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains 
 |
Time for another episode of "Overthinking the Build." I planned to braze in the fresh air tube in the door jamb and the corner at the bottom of the jamb to match what the factory did. Brazing makes sense in those spots. Problem is, I don't have a torch and haven't been able to find one to rent or borrow (we are down to only one tool rental outfit around here). Can't justify the expensive of an acetylene torch. Bernzomatic has a cheap MAPP/Oxygen brazing rig but the reviews are pretty much universally shitty. Starting to think grabbing the MIG and being done with it is the way to go. Let's assume this was a "high end" restoration. Would that be acceptable?
  |
   |
 
|
Posts in this topic
bbrock door jamb air tube Feb 7 2018, 10:48 AM
bbrock The question may be moot. Sounds like my neighbor... Feb 7 2018, 11:53 AM Tom_T
.... Let's assume this was a "high end... Feb 7 2018, 12:13 PM defianty I've just done mine today and I just used a fe... Feb 7 2018, 12:18 PM bbrock Thanks guys! Everything you've said is ri... Feb 7 2018, 02:10 PM MarkV Maybe you already know this or maybe it doesn... Feb 7 2018, 04:37 PM
bbrock
Maybe you already know this or maybe it doesn... Feb 7 2018, 06:40 PM gothspeed
I've just done mine today and I just used a f... Feb 7 2018, 06:55 PM bbrock
I've just done mine today and I just used a ... Feb 7 2018, 08:58 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th May 2024 - 12:42 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.