Home  |  Forums  |  914 Info  |  Blogs
914World.com - The fastest growing online 914 community!
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.

Welcome Guest ( Log In | Register )

> Body stiffening using donor car longs and rear firewall
post Feb 13 2018, 09:00 AM
Post #1

Senior Member

Group: Members
Posts: 648
Joined: 1-December 17
From: soCal
Member No.: 21,666
Region Association: None

IF the donor car is going to get cut up (this is the one without vin numbers where the front clip has some funky stuff going on) couldn't I harvest the inner longs and bottom of the rear firewall to weld into my 914/6 project?

Similar to the Maddog interior bracing kit but using the actual factory stampings? The 2.7 or 3.0l engine will handle the modest weight easily I think.

Mark, you did this on your Orange car if memory serves, right?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


- Lo-Fi Version Time is now: 22nd October 2018 - 08:08 PM