 Replacing trunk firewall perlon, How did you do it and other questions.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim_hoyland |
 Jun 11 2018, 04:55 PM
Post
#1
|
|
Get that VIN ?  Group: Members Posts: 9,263 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
 |
I acquired a new piece of pre-cut perlon from 914Rubber and have done some limited test fitting. Since I only get one shot at gluing the perlon, i’m Looking for advice from someone that’s done this.
Type of glue, tools, solo or Help . Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
jim_hoyland Replacing trunk firewall perlon Jun 11 2018, 04:55 PM
Lucky9146 One of my early projects.
Masked off and used spra... Jun 11 2018, 05:47 PM jim_hoyland Thanks. Good suggestion to mask; did you spray the... Jun 11 2018, 06:39 PM
Lucky9146
Thanks. Good suggestion to mask; did you spray th... Jun 11 2018, 09:09 PM mepstein With contact adhesive, usually if you just spray o... Jun 11 2018, 07:30 PM Larmo63 I'd use 3M 90 and spray both surfaces.......
... Jun 11 2018, 09:33 PM Perry Kiehl I mask everything and then only apply glue to top ... Jun 12 2018, 06:37 AM jim_hoyland
I mask everything and then only apply glue to top... Jun 12 2018, 07:29 AM Rocky Jim, I hated to ruin the paint underneath so I use... Jun 12 2018, 07:58 AM theer This is on my to-do list as well...
Probably not ... Jun 12 2018, 12:30 PM Lucky9146
This is on my to-do list as well...
Probably not... Jun 12 2018, 12:52 PM jim_hoyland
This is on my to-do list as well...
Probably no... Jun 12 2018, 04:56 PM theer Great - thanks. Jun 12 2018, 03:07 PM jim_hoyland Another question while we are at the front trunk f... Jun 12 2018, 05:02 PM raynekat
Another question while we are at the front trunk ... Jun 12 2018, 05:09 PM jim_hoyland After looking at some front trunk pics, I'm cu... Jun 13 2018, 05:51 AM jim_hoyland I found that rare-earth magnets are perfect for po... Jun 17 2018, 01:24 PM jim_hoyland Should I pre-cut an opening for the ID plate ? Or,... Jul 4 2018, 03:47 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th April 2024 - 12:06 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.