Home  |  Forums  |  914 Info  |  Blogs
914World.com - The fastest growing online 914 community!
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.

Welcome Guest ( Log In | Register )

> Roll Bar Aluminum Trim Install, Install Question
post Nov 1 2018, 11:21 AM
Post #1


Group: Members
Posts: 597
Joined: 13-June 06
From: League City Texas
Member No.: 6,213
Region Association: None

When installing the 3 aluminum trim pieces on roll bar, are the 2 side trim pieces the only support for the top roll bare piece. The reason I’m asking is on my previous 914 I thought there was a clip in the center of the trim piece that fit in a hole in the bar to hold it in place. Thanks
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Reply to this topicStart new topic
post Nov 9 2018, 01:03 PM
Post #2

Advanced Member

Group: Members
Posts: 3,349
Joined: 23-November 05
From: Paramus NJ
Member No.: 5,176
Region Association: None

Just to clarify...The clips are slid into the horizontal aluminum trim then the piece is
pushed onto the pinch weld.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


- Lo-Fi Version Time is now: 29th October 2020 - 04:26 AM