 Question for Engine Gurus.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| MikeM |
 Dec 5 2018, 10:10 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 564 Joined: 16-May 10 From: Calgary, Canada Member No.: 11,733 Region Association: Canada  |
Hi all...I'm planning some engine work for my 74 2.0 liter.
I've been advised to use the 96mm pistons and cylinders from AA. Do the experienced engine guys here use the RINGS that come with the P and C's from AA, or do you use something else? Thanks!! |
   |
 
|
  |
Replies
| ottox914 |
Dec 5 2018, 07:30 PM
Post
#2
|
|
The glory that once was. Group: Members Posts: 1,302 Joined: 15-December 03 From: Mahtomedi, MN Member No.: 1,438 Region Association: Upper MidWest  |
+1 for Mark. Also +1 for oem iron jugs overbored, KB slugs, and Hastings rings.
|
|
|
|
Posts in this topic
MikeM Question for Engine Gurus.... Dec 5 2018, 10:10 AM
Mblizzard I purchased some other rings for mine. Not sire o... Dec 5 2018, 10:46 AM cuddy_k :agree:
I'm (very) far from an engine guru, b... Dec 5 2018, 11:08 AM BeatNavy I purchased JE pistons through AA recently and the... Dec 5 2018, 11:51 AM StratPlayer If your going to do a 96 mm setup I would buy my j... Dec 5 2018, 12:32 PM
StratPlayer [quote name='StratPlayer' post='267132... Dec 5 2018, 12:33 PM MikeM What do you mean by "my" jugs?
Mike Dec 5 2018, 02:52 PM Tdskip Jugs (here anyway) = bores where the pistons go Dec 5 2018, 05:07 PM MikeM Yes I know that...he said buy "MY" jugs.... Dec 5 2018, 06:08 PM Olympic 914 With the Keith Black hypereutectic pistons the top... Dec 5 2018, 06:10 PM burton73 Get a hold of Mark Henry up in your neck of the wo... Dec 5 2018, 06:49 PM MikeM This is all good information. Just to be clear, I... Dec 5 2018, 10:15 PM Mark Henry
This is all good information. Just to be clear, I... Dec 6 2018, 07:37 AM cgnj What's the current cost of getting cylinders t... Dec 6 2018, 12:55 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th May 2024 - 05:48 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.