 Strange Noise, Strange Howling up front |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jdamiano |
 Dec 6 2018, 08:14 AM
Post
#1
|
|
Member  Group: Members Posts: 335 Joined: 18-March 18 From: Jacksonville Member No.: 21,981 Region Association: South East States  |
I thought I would drive the 914 in to work this morning since it’s going to be nice today in Jacksonville but I had to turn around and go home. It was just above freezing when I left the house but I was dressed to deal. The problem was a howling noise that sounded like it was coming from in front of me. It was an on or off noise that came on once the car got to about 15 mph. Stopped when I slowed down. Had no affect on the car running and turning the heater off had no affect on the noise. Kinda sounds like an angry ghost trying to scare me. Any idea what it could be?
|
   |
 
|
  |
Replies
| jdamiano |
Dec 8 2018, 06:31 AM
Post
#2
|
|
Member Group: Members Posts: 335 Joined: 18-March 18 From: Jacksonville Member No.: 21,981 Region Association: South East States |
It’s the speedo cable. Speedo is acting weird and the sound changes with the needle bounce. Any tricks to replacing it?
|
|
|
|
| Tdskip |
Dec 8 2018, 07:55 AM
Post
#3
|
|
Advanced Member Group: Members Posts: 3,686 Joined: 1-December 17 From: soCal Member No.: 21,666 Region Association: None 
|
QUOTE(jdamiano @ Dec 8 2018, 07:31 AM)  It’s the speedo cable. Speedo is acting weird and the sound changes with the needle bounce. Any tricks to replacing it? Glad it was something simple. From jim912928 I just replaced mine...entire sheath and all. It was very easy. First..attach some string to the speedo (interior) end and pull the cable out from the rear (after disconnecting from the angle drive of course). Next tie the string onto the new end and pull it back into the car from the front end of the tunnel. Screw back into the speedo and the angle drive and you are done! Took me about 15 minutes cause you have to do some stuff like remove the drivers side carpet..the little access cover up by the gas peddle on the tunnel etc. Once you pull it through make sure it's not tangled with the throttle cable and clutch cable. But if you use the string to pull it out and back in you should be done! |
|
|
|
Posts in this topic
jdamiano Strange Noise Dec 6 2018, 08:14 AM
Tdskip Front of the car inside the cockpit or out side th... Dec 6 2018, 08:29 AM mepstein wheel bearing? Dec 6 2018, 08:34 AM
majkos1
wheel bearing?
:agree:
happen to me on driver... Dec 6 2018, 09:24 AM dr914@autoatlanta.com sounds like a front wheel bearing, everyone forget... Dec 6 2018, 09:52 AM jdamiano The weird thing was it didn’t seem proportional ... Dec 6 2018, 12:03 PM mepstein The howling noise is pretty common for wheel beari... Dec 6 2018, 12:29 PM PanelBilly I have a similar noise that comes and goes. It sou... Dec 6 2018, 01:48 PM Larmo63 Installing a new speedometer cable take all of an ... Dec 6 2018, 01:58 PM drifter914 Seen your dog lately ? Dec 6 2018, 07:26 PM jdamiano
It’s the speedo cable. Speedo is acting weird ... Dec 8 2018, 10:03 AM jdamiano For anyone using this thread to troubleshoot in th... Dec 8 2018, 10:00 AM PanelBilly Oh good. Another job I can do. What’s the best p... Dec 8 2018, 10:04 AM jaredmcginness Resurrecting this thread to thank @jdamiano . I l... Feb 7 2023, 06:27 AM emerygt350 that happened to me right after I bought the car, ... Feb 7 2023, 08:38 AM Olympic 914 before I reinstalled the cable, I hung it from the... Feb 8 2023, 10:15 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th May 2024 - 05:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.