Stock Push Rod Length |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Stock Push Rod Length |
R Dub |
Mar 14 2019, 01:14 PM
Post
#1
|
Member Group: Members Posts: 120 Joined: 29-August 17 From: Burbs of Chicago Member No.: 21,387 Region Association: None |
Can anyone verify what the stock push rod length is for these cars?
From my research the stock length is 271mm and the stock part# 021-109-301-A. I ordered 2 of these to replace the 2 bent ones that I have. I have no history of what push rods were in my motor so I just assumed they were stock but it doesn't appear that way as my 2 new ones are about 1/4" longer than what was in there. Just want to verify before I go buy 6 more stock rods. |
R Dub |
Mar 15 2019, 11:46 AM
Post
#2
|
Member Group: Members Posts: 120 Joined: 29-August 17 From: Burbs of Chicago Member No.: 21,387 Region Association: None |
Post a couple of photos of both. Will do once I can get back there to snap a pick of the ones that were in it. Do you have a solid or hydraulic lifter engine? You need to measure one of your non bent pushrods. You may have custom lenght rods which is commom depending on how the engine was built. It had a hydraulic lifters in it. I am switching over to solid based on the advise of this forum. |
Lo-Fi Version | Time is now: 29th March 2024 - 05:30 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |