Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> A question about wire sizes, oil temperature sensor
ericoneal
post May 13 2019, 07:29 PM
Post #1


Member
**

Group: Members
Posts: 320
Joined: 13-August 12
From: Crestwood, KY
Member No.: 14,795
Region Association: South East States



After some spirited driving lately, my oil temperature has been up in the 240-260 range, where it has never been before.
I have checked that the flaps are fully open and that there is no mouse nest, that I can see or feel, in the fan...

I recently re-installed the engine after some work and ran a large red wire from the oil sensor in the taco plate up to the top of the engine and connected it with the smaller gage green wire. Could this cause a misreading? Seems unlikely, but I'm just looking for ideas at this point.

I pulled the dipstick and its hot, but I can hold it, so I seem to think the gauge is just reading high.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 16th May 2024 - 11:04 PM