 Trailing arm bushings, Install procedure for 914 Rubber bushings |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Morph914 |
 May 13 2019, 07:48 PM
Post
#1
|
|
Member  Group: Members Posts: 435 Joined: 22-August 16 From: St Augustine, FL Member No.: 20,326 Region Association: South East States 
 |
I purchased these along with my a arm bushings. I am about to install the a arm bushings and have a clear understanding of how to install those, but not the trailing arm bushings. I have watched a video on the trailing arm bushings install, but the type of bushing he was using is unknown unless I missed something. Do 914 Rubber trailing arm bushings get installed with grease? Are these rubber or teflon?
Thanks for any input, John   |
   |
 
|
  |
Replies
| bbrock |
May 14 2019, 05:40 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains
|
Hey John,
I used electrical tape to wrap around the tools to take out the slop. IIRC, each end of the A-arm was a little different. Sorry you had bad luck on the first try. I didn't used a temp gun on the boiling water either but because I'm at altitude, I boiled them for a good 20-30 minutes. |
|
|
|
Posts in this topic
Morph914 Trailing arm bushings May 13 2019, 07:48 PM
bbrock Those are harder rubber than the A-arm bushings an... May 13 2019, 08:10 PM
mepstein
Those are harder rubber than the A-arm bushings a... May 13 2019, 08:37 PM Morph914 Thank you.
Well, I thought I had everything I nee... May 14 2019, 05:11 PM Morph914 Thanks, I’ll try boiling for a longer period of ... May 14 2019, 08:07 PM mepstein Boiling water only gets to 212 no matter how long ... May 14 2019, 08:42 PM bbrock
Boiling water only gets to 212 no matter how long... May 14 2019, 10:48 PM bdstone914 @[url=http://www.914world.com/bbs2/index.php?showu... May 15 2019, 08:43 AM bigkensteele I used a Harbor Freight 12 ton press to install my... May 14 2019, 09:09 PM Dr916Gt Just did these last week converted my 914 to a six... May 15 2019, 09:48 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th April 2024 - 03:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.