 Transmission cooler placement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| vintage914racer |
 Aug 16 2019, 01:56 PM
Post
#1
|
|
Member  Group: Members Posts: 429 Joined: 28-December 03 From: Minneapolis, MN Member No.: 1,473  |
It’s time to add a transmission cooler to my 914-6 vintage race car. Curious what folks have to say about cooler placement. Presumably the air is hot underneath the rear trunk and I do t know how much it flows. Any suggestions on where to place it?
|
   |
 
|
| Steve |
Aug 17 2019, 07:27 AM
Post
#2
|
|
914 Guru Group: Members Posts: 5,573 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California 
|
John Williamson aka Otto built a nice setup on my car. I removed it all when I installed my 915. I will post some pictures later. It was installed next to the trans on the right side.
|
 |
|
| Krieger |
Aug 17 2019, 08:15 AM
Post
#3
|
|
Advanced Member Group: Members Posts: 4,705 Joined: 24-May 04 From: Santa Rosa CA Member No.: 2,104 Region Association: None
|
I put my trans cooler in my right rear fender ahead of the wheel. I have a scoop on the outside of the car. I suspect there is quite a bit of air moving inside the fender to do the job.
|
|
|
|
| Krieger |
Aug 17 2019, 08:17 AM
Post
#4
|
|
Advanced Member Group: Members Posts: 4,705 Joined: 24-May 04 From: Santa Rosa CA Member No.: 2,104 Region Association: None
|
Do your rules allow? An under body scoop may work too
Attached image(s) 
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th May 2024 - 06:55 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.