How Best to Measure for Bodywork |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
How Best to Measure for Bodywork |
bkrantz |
Dec 8 2019, 09:29 PM
Post
#1
|
914 Guru Group: Members Posts: 7,749 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains |
...without a jig.
I am splicing in the right front headlight box, forward section of the inner fender, and the vertical brace. I am keeping the original floor, and the semi-original front panel, which got pretty banged up. My approach has been to get the straight splice section located properly, and then use that as a guide to work the end of the front panel into proper shape. I have been measuring distances between as many reference points as possible, and comparing the right side to the unmolested left side. At this point I have a pretty good match, referencing spots like the upper edges of the headlight box, the headlight pivot hardware mounting points, corners on the brace, etc. relative to the gas tank bulkhead upper edge and front panel. I have also measured and compared angles. And I propped the front hood in place, and compared to that. At this point, I have everything within a 1/16 inch and 1 degree. Anything else to consider or measure? Attached thumbnail(s) |
Lo-Fi Version | Time is now: 5th May 2024 - 07:40 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |