 Help with floor cross brace location |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| bkrantz |
 Feb 7 2020, 05:17 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 7,768 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains 
 |
I am about to weld in the new floor cross brace and would like to get this in the right place! I have my measurements from the old, rusty floor but would like to confirm. Can someone please get a measurement between the firewall and the rear surface of the cross brace (back to front)?
Attached thumbnail(s) 
|
   |
 
|
| dr914@autoatlanta.com |
Feb 7 2020, 05:35 PM
Post
#2
|
|
914 Guru Group: Members Posts: 7,866 Joined: 3-January 07 From: atlanta georgia Member No.: 7,418 Region Association: None |
   |
|
|
|
| burton73 |
Feb 7 2020, 05:38 PM
Post
#3
|
|
burton73 Group: Members Posts: 3,526 Joined: 2-January 07 From: Los Angeles Member No.: 7,414 Region Association: Southern California
|
18 1/4 inch on my 74
Bob B  |
|
|
|
| burton73 |
Feb 7 2020, 05:43 PM
Post
#4
|
|
burton73 Group: Members Posts: 3,526 Joined: 2-January 07 From: Los Angeles Member No.: 7,414 Region Association: Southern California
|
I Cked my car 2 times.
|
|
|
|
| bkrantz |
Feb 7 2020, 09:05 PM
Post
#5
|
|
914 Guru Group: Members Posts: 7,768 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains
|
Thanks very much, gents. Looks like you both measure just a bit more than 18-1/4". That's what I have recorded, and will use that.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st May 2024 - 02:25 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.