 Torque settings? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Robson51 |
 Feb 13 2020, 05:09 PM
Post
#1
|
|
Member  Group: Members Posts: 88 Joined: 18-November 19 From: seattle Member No.: 23,654 Region Association: Pacific Northwest  |
I've used the search settings and also googled this question. Searching this site produced nothing and Google gives more than one answer.
What is the torque wrench setting for the intake manifold nuts? I have seen numbers from 4 (!) to 10 ft lbs. What is the torque setting for the rocker arms? Again, a couple different numbers but 14 ft lbs seems the middle. Any advice here? Thanks Rob |
   |
 
|
  |
Replies
| iankarr |
Feb 14 2020, 09:19 AM
Post
#2
|
|
The wrencher formerly known as Cuddy_K Group: Members Posts: 2,472 Joined: 22-May 15 From: Heber City, UT Member No.: 18,749 Region Association: Intermountain Region 
|
The Haynes manual has a lot of torque values at the beginning of each section. For 8.8 grade M8, the standard torque is 17 ft-lbs.
|
|
|
|
Posts in this topic
Robson51 Torque settings? Feb 13 2020, 05:09 PM
914werke Because I hear this Q pretty often I posted a tabl... Feb 13 2020, 05:12 PM
Robson51
Because I hear this Q pretty often I posted a tab... Feb 13 2020, 05:16 PM
krazykonrad
Because I hear this Q pretty often I posted a tab... Jan 19 2021, 10:27 AM Mark Henry
The Haynes manual has a lot of torque values at t... Feb 14 2020, 09:43 AM Robson51
The Haynes manual has a lot of torque values at t... Feb 14 2020, 10:45 AM Tbrown4x4 Possibly because of the phenolic spacer between th... Feb 14 2020, 11:03 AM rhodyguy Value is based on the stud size. Not the nut. Feb 14 2020, 11:04 AM Robson51
Value is based on the stud size. Not the nut.
I... Feb 14 2020, 11:16 AM stephenf
Value is based on the stud size. Not the nut.
... Jan 18 2021, 06:44 PM ClayPerrine
Value is based on the stud size. Not the nut.
... Jan 19 2021, 07:38 AM Jake Raby I torque intake nuts to 15#. 4# is no where near e... Jan 19 2021, 07:50 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th May 2024 - 11:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.