PO Repair Hall of Shame, Let's see all the nasty, half-a** repairs we can blame on somebody else |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
PO Repair Hall of Shame, Let's see all the nasty, half-a** repairs we can blame on somebody else |
bkrantz |
Apr 5 2020, 08:40 PM
Post
#1
|
914 Guru Group: Members Posts: 7,766 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains |
Here's one of mine. A 2 inch lap joint in the rear fender, with a raw, open edge inside. And lots of bondo outside.
Attached thumbnail(s) |
carl k |
Jun 5 2020, 01:52 PM
Post
#2
|
Member Group: Members Posts: 76 Joined: 19-August 08 From: San Jose, CA Member No.: 9,440 Region Association: None |
After burning through the nylon tunnel fuel lines while repairing a broken clutch tube, a P.O. decided to run new fuel lines UNDER the floor pan. And they made them out of COPPER TUBING!!!!!
|
Lo-Fi Version | Time is now: 18th May 2024 - 09:41 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |