PO Repair Hall of Shame, Let's see all the nasty, half-a** repairs we can blame on somebody else |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
PO Repair Hall of Shame, Let's see all the nasty, half-a** repairs we can blame on somebody else |
bkrantz |
Apr 5 2020, 08:40 PM
Post
#1
|
914 Guru Group: Members Posts: 7,773 Joined: 3-August 19 From: SW Colorado Member No.: 23,343 Region Association: Rocky Mountains |
Here's one of mine. A 2 inch lap joint in the rear fender, with a raw, open edge inside. And lots of bondo outside.
Attached thumbnail(s) |
914forme |
Jun 6 2020, 05:03 PM
Post
#2
|
Times a wastin', get wrenchin'! Group: Members Posts: 3,896 Joined: 24-July 04 From: Dayton, Ohio Member No.: 2,388 Region Association: None |
Hey at least they knew what clamps to use to properly support them copper Fuel lines, and not a bad use of the floor indent really. Most other cars have them hanging below the car.
Now I guess your lucky the Aluminum plate guy was not around, I could see a strip of that ran down the underside to span tunnel indent. |
Lo-Fi Version | Time is now: 24th May 2024 - 07:47 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |