 Crown and pinion wear patrern, Didn’t change pinion bearings , shims or paper gaskets |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| panayotisnikas |
 Apr 8 2020, 10:33 AM
Post
#1
|
|
Newbie  Group: Members Posts: 25 Joined: 12-March 20 From: Greece Member No.: 24,021 Region Association: None  |
Hello everybody , I just finished flipping my 914 gearbox to use in a beetle , I replaced 1st gear dog teeth and synchro ring , diff bearings , input shaft bearing . I set the preload for the diff , backlash is correct . I don’t think the engineering blue
I found is the best in the world because it’s hard to leave Marks on and kind of peels . I did my best to get a reading . I didn’t mess with the pinion bearing or it’s shims, neither with the paper gaskets between the case and the intermediate plate . So I wouldn’t expect having altered the pinion depth . Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
panayotisnikas Crown and pinion wear patrern Apr 8 2020, 10:33 AM
panayotisnikas Also a pic from the other side Apr 8 2020, 10:34 AM Superhawk996 Delete duplicate post Apr 8 2020, 01:27 PM
Superhawk996 I'm not a trans expert . . . Calling Dr_Evil... Apr 8 2020, 01:31 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th May 2024 - 08:04 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.