 Rusteration rebuild, Building a vintage racer |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Duane921 |
 May 23 2020, 05:22 AM
Post
#1
|
|
Newbie  Group: Members Posts: 17 Joined: 29-August 13 From: San Antonio, Texas Member No.: 16,322 Region Association: None  |
QUOTE(Dr Evil @ Jun 9 2008, 07:59 PM)  My goal is to build a vintage racer. I have restored one 914 already but want to have a little fun with this one. It is in need of a lot of work but that's the part i enjoy most. I have the car completely stripped down and parts are in for the rear floor pan, cross member, and inner firewall. The car is on a rotisserie and has been supported with braces in the door wells and measurements are dead on. That's the good part. The bad part comes next. Time to remove those pieces. That's where i can use some advice. Is there a best way to remove those or do i just start cutting away? Attached thumbnail(s)  
|
   |
 
|
Posts in this topic
Duane921 Rusteration rebuild May 23 2020, 05:22 AM
Cairo94507 I would spend some time reading a lot of the resto... May 23 2020, 06:34 AM
Duane921
I would spend some time reading a lot of the rest... May 23 2020, 07:08 AM bkrantz On my project, I cut out the rear half of the floo... May 23 2020, 08:38 PM bbrock If it were me, I'd do them one at a time start... May 23 2020, 08:41 PM Duane921
If it were me, I'd do them one at a time star... May 24 2020, 04:03 AM budk Add bracing to maintain the door gap. I did door ... May 24 2020, 06:02 AM Duane921 I have similar door braces already. I like what yo... May 24 2020, 08:01 AM Duane921 Let the surgery begin. Cross braces are now in pla... Jun 22 2020, 03:44 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 09:24 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.