 1.7 Push Rods-wear, what would cause |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Pops71Por |
 Jan 17 2021, 07:40 PM
Post
#1
|
|
Newbie  Group: Members Posts: 15 Joined: 30-December 20 From: NC Member No.: 25,032 Region Association: South East States  |
new to the 914 world and try hard to get this one road worthy.
recently purchased 1971 1.7L. got running after 5 years sitting. was having rough idle and oil leaks so I pulled engine to overall tasks (easier when out of car) and clean up When I got to replacing the pushrod tube, I looked at the rods and was getting this wear on 3 of 4 rods. see arrows Happening on both sides. valves are okay, checked compression, all good but tops of pistons were very sooty and also were all plugs what would cause the wear? do they need replaced or can i flip them upside down additionally can this be part of the rough idle and sooty build-up?  |
   |
 
|
Posts in this topic
Pops71Por 1.7 Push Rods-wear Jan 17 2021, 07:40 PM
914werke Ive seen this when the tube retention wire isnt co... Jan 17 2021, 10:52 PM
dlee6204
Ive seen this when the tube retention wire isnt c... Jan 18 2021, 06:11 PM Pops71Por
Ive seen this when the tube retention wire isnt ... Feb 11 2021, 03:44 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th May 2024 - 11:40 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.