 Welding partial bottom piece at the rear |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Leon.paradise |
 May 16 2021, 04:10 PM
Post
#1
|
|
Newbie  Group: Members Posts: 10 Joined: 30-December 19 From: Munich Member No.: 23,780 Region Association: None  |
Hello,
I would like to replace and weld in part of the floor panel at the rear of my 914. I have a question to which I have not found an answer on the Internet. When I weld in the floor pan I have to completely remove the 2 plastic fuel lines (flow and return) from the tunnel or I can leave them in when welding the floor pan. I am specifically concerned with the risk of fire. The heat when welding sheet metal can cause the fuel lines to melt or the heat to make the lines so hot that what can happen. The engine and tank are still installed in the vehicle as normal. What about the engine and tank, can they be built in or do they have to be removed before I start welding. The carpet, seats, seat back wall will of course be removed by me beforehand. Pictures of the area   Greetings Leon |
   |
 
|
Posts in this topic
Leon.paradise Welding partial bottom piece at the rear May 16 2021, 04:10 PM
rjames My $.02: Since you're in there just repla... May 16 2021, 04:46 PM ndfrigi yes please just replace the original fuel lines to... May 16 2021, 05:29 PM IronHillRestorations Anything you can possibly burn, melt, or char shou... May 17 2021, 06:46 AM
Mark Henry
Anything you can possibly burn, melt, or char sho... May 17 2021, 06:55 AM
VaccaRabite
Anything you can possibly burn, melt, or char sho... May 17 2021, 08:49 AM Leon.paradise Hello,
What does it look like if I want to weld w... May 17 2021, 02:01 PM Superhawk996
What does it look like if I want to weld with a ... May 17 2021, 04:01 PM ddire333 I'm using flux core on my 914 restore currentl... May 17 2021, 11:00 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th April 2024 - 07:04 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.