 main bearings, preferred manufacturer |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 930cabman |
 Nov 27 2021, 09:55 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,003 Joined: 12-November 20 From: Buffalo Member No.: 24,877 Region Association: North East States 
 |
I recently purchased a standard size main bearing set from a large vendor, checking the clearances I am finding this new set will provide a clearance at the high limit per factory specs. My crank is spot on, but the main bearing ID appears too large. I can easily fit a .004 feeler between the crank and new bearing ID. Just for fun, I tried an old (used)main bearing and found it to have a smaller ID (by about .0015) than a new one. Am I missing something?
Thanks |
   |
 
|
  |
Replies
| iankarr |
Nov 27 2021, 04:06 PM
Post
#2
|
|
The wrencher formerly known as Cuddy_K Group: Members Posts: 2,472 Joined: 22-May 15 From: Heber City, UT Member No.: 18,749 Region Association: Intermountain Region
|
There's been lots of talk about quality beinig all over the place with new bearings. I had to go through two sets of Silverline before we had a workable combo. Tabari Andrade on the samba has a line on new german bearings which look promising.
|
|
|
|
| AndradeT |
Nov 28 2021, 09:35 PM
Post
#3
|
|
Newbie Group: Members Posts: 1 Joined: 23-February 21 From: Los Angeles, CA Member No.: 25,252 Region Association: Southern California |
QUOTE(iankarr @ Nov 27 2021, 04:06 PM)  There's been lots of talk about quality beinig all over the place with new bearings. I had to go through two sets of Silverline before we had a workable combo. Tabari Andrade on the samba has a line on new german bearings which look promising. Thanks again Ian! |
|
|
|
Posts in this topic
930cabman main bearings Nov 27 2021, 09:55 AM
914Sixer You have to remember that your old bearing shell h... Nov 27 2021, 01:37 PM
930cabman
You have to remember that your old bearing shell ... Nov 27 2021, 04:31 PM iankarr
There's been lots of talk about quality bein... Nov 30 2021, 11:01 PM 914Sixer Yes the old bearing remains crushed. Yes you can ... Nov 27 2021, 07:14 PM Mark Henry Yes the bearings is a torqued spec. Plastigauge is... Nov 28 2021, 01:06 PM 930cabman Crushed!!
I may have known this in the pa... Nov 30 2021, 11:26 AM 930cabman Yes, as expected: I did assemble the crank/new mai... Nov 30 2021, 06:54 PM 930cabman Yes, as expected: I did assemble the crank/new mai... Nov 30 2021, 06:55 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th April 2024 - 01:50 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.