 Exhaust Stud Pulled Out |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Ecterg42 |
 Jun 3 2022, 10:47 AM
Post
#1
|
|
Newbie  Group: Members Posts: 8 Joined: 16-July 21 From: Milford, PA Member No.: 25,730 Region Association: North East States  |
Hi folks, while tightening exhaust manifold nuts, one stud 'pulled out'. Small steel crescents fell out and were wound tight around the stud, evidence that a repair had been made previously. I figure that I should drill and tap the hole for a step stud. The engine is in the car, the car on a Quick Jack.
Any tips on drilling out and tapping the hole while under the car. As I will need to buy a tap, exactly what type/size should I get? I read on another thread that someone made a drilling jig for this purpose. Would something like that be needed/advisable for this job? Does anyone have one to lend? Also, what are the torque specs for the stud and nuts? |
   |
 
|
Posts in this topic
Ecterg42 Exhaust Stud Pulled Out Jun 3 2022, 10:47 AM
Shivers My personal opinion, they are a bit pricey but Tim... Jun 3 2022, 12:08 PM rjames
My personal opinion, they are a bit pricey but Ti... Jun 3 2022, 01:49 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 01:58 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.