 Tail shifter shaft, It's all worn out! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Jaiden |
 Aug 4 2005, 07:36 AM
Post
#1
|
|
Member  Group: Members Posts: 346 Joined: 13-January 05 From: Stroudsburg PA Member No.: 3,443  |
So I had the car up on Jack stands last night to take a closer look at some of the things I have on my To Do list and While inspecting the shift linkage I notice that instead of finding that my sloppy shifting is due to worn bushings I found that the actual shaft is worn out!!!
Also where the shaft sets into the tranny shift linkage should there be a bushing there or just grease? Now how can I go about fixing this? I took a look at how the shaft is mounted and up front the bushing is good but I'm not sure how to remove the shaft. I would like to either replace the shaft or possibly increase the diameter with added metal or even epoxy. I don't mind the tailshifter as I feel a properly set up peice should work fine. Any Ideas? |
   |
 
|
Posts in this topic
Jaiden Tail shifter shaft Aug 4 2005, 07:36 AM
Joe Ricard I've got a whole tail shift set up. Let me kno... Aug 4 2005, 07:42 AM Jaiden Joe could you take a pick of where the rear of the... Aug 4 2005, 07:46 AM Jaiden Could I add JB weld to the shaft and then sand it ... Aug 4 2005, 09:22 AM Mueller Aug 4 2005, 09:37 AM lapuwali Yes. Red-Beard even recommends this (or brazing i... Aug 4 2005, 09:57 AM
Red-Beard I used brazing material, but J weld should work. T... Aug 4 2005, 02:40 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 09:22 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.