 Dropping engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914-Kazoo |
 Jul 16 2022, 06:19 AM
Post
#1
|
|
Newbie  Group: Members Posts: 45 Joined: 19-August 20 From: Kalamazoo, MI Member No.: 24,609 Region Association: Upper MidWest  |
I'm planning on dropping the engine out of my 1974 2.0 liter 914. I've got my car on a BackYard Buddy drive on lift. I have a concern that the clearances between the ramps could interfere with engine removal.
Does anyone know the measurements across the engine? Thanks for the help. |
   |
 
|
Posts in this topic
914-Kazoo Dropping engine Jul 16 2022, 06:19 AM
mepstein A lot of times you need to angle the engine so the... Jul 16 2022, 07:50 AM mgphoto Factory manual says the body should be 27 inches o... Jul 16 2022, 11:22 AM GBX0073 +1 remove the rear valance Jul 16 2022, 12:33 PM NARP74 I think he is talking width, not height. Jul 16 2022, 02:35 PM
914-Kazoo
I think he is talking width, not height.
Yes, ... Jul 16 2022, 05:22 PM rgalla9146 Measure the width of the cast iron engine support.... Jul 16 2022, 06:15 PM bkrantz If you remove the cross bar, the widest dimension ... Jul 16 2022, 09:03 PM davep Here is one really good trick. I have done a lot o... Jul 16 2022, 09:28 PM Amphicar770 I ran into this issue with my 4-post lift. Here i... Jul 17 2022, 05:54 PM 914-Kazoo
I ran into this issue with my 4-post lift. Here ... Jul 25 2022, 07:26 PM VaccaRabite Take it off the lift/ramps and use a jack and jack... Jul 26 2022, 08:38 AM Superhawk996
It is NOT hard to do using a jack and jackstands.... Jul 26 2022, 09:39 AM 914-Kazoo Thanks for the replies, your right I'm overthi... Jul 30 2022, 07:26 PM ChrisFoley Hi Malcolm.
Not sure why the USPS couldn't del... Jul 31 2022, 04:41 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 11:02 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.