 transmission question, I don't want to make a mistake. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ehick72 |
 Sep 21 2005, 12:34 PM
Post
#1
|
|
Member  Group: Members Posts: 108 Joined: 28-December 04 From: Austin, Texas Member No.: 3,356  |
I have put a new clutch and flywheel in. I used a clutch alignment tool up until the point where I jacked the transmission up and got it onto the bolts. However it is not going in completely. Is the transmission shaft out of alignment? I actually got one bolt to thread and I can continue to tighten it down but I wanted to make sure that I am doing the right thing. What if I force the shaft in and the teeth are a little out of align?
|
   |
 
|
Posts in this topic
ehick72 transmission question Sep 21 2005, 12:34 PM
ehick72 should I just tighten it down and hope for the bes... Sep 21 2005, 01:05 PM adam912 This is really common. Rotate the engine (or the ... Sep 21 2005, 01:15 PM Cap'n Krusty Put the trans in gear, grab the stub axles, and tu... Sep 21 2005, 01:18 PM aircooledboy Put the trans into any gear with your hand. Have a... Sep 21 2005, 01:21 PM aircooledboy http://www.914world.com/bbs2/htm... Sep 21 2005, 01:21 PM
ehick72 Good I was right you guys. I thought it should go... Sep 21 2005, 01:36 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 11:00 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.