 Question 2, High Idle - yet again |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BenNC |
 Aug 19 2003, 04:04 PM
Post
#1
|
|
Member  Group: Members Posts: 140 Joined: 7-February 03 From: Cary, NC Member No.: 267  |
I know, there have been a gazillion posts about high idle. Most of them seem to end with check al the hoses and set the timing.
I have replaced all the hoses, and set the timing. With the idle adjust screw all the way clockwise I idle at about 1800 rpm. Per my Haynes manual, turning the screw counterclockwise whould lower the speed, butthe idle increases for me. Is this an error in the book, and what should I look at next. By the way. It idled fine until the points of undetermined age froze on me. It idled fast with new points and has continued with the new Pertronix. Thanks |
   |
 
|
Posts in this topic
BenNC Question 2 Aug 19 2003, 04:04 PM
jkeyzer Clockwise should reduce the idle speed. You'r... Aug 19 2003, 04:09 PM Dave_Darling Which idle adjust are you turning? The one on the... Aug 19 2003, 04:12 PM BenNC I'm putzing with the screw on the throttle bod... Aug 19 2003, 04:18 PM Bleyseng If the screw on the throttle body doesn't slow... Aug 19 2003, 04:25 PM jkeyzer Did you retime the engine after you changed the po... Aug 19 2003, 04:28 PM BenNC Timing was set after adding the Pertronix. The ne... Aug 19 2003, 04:33 PM
Bleyseng Likely leaks?
injector seals
throttle body to plen... Aug 19 2003, 05:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 08:31 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.