 Oil cooler..........round two, AKA fun with foam! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| East coaster |
 Feb 17 2006, 07:56 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,671 Joined: 28-March 03 From: Brigantine, NJ Member No.: 487 Region Association: None 
 |
So after a little brainstorming on an oil cooler layout, I figured I better actually do it.
Started out by figuring out the mounting of the cooler itself. It's a very large (4 x 24 fin area) and I think a good fit for a 3.6 since it doesn't have an engine mounted cooler. I started by cutting sections out of the front support tray for clearance and then re-boxing the area to keep the shelf rigid and serve as a mounting point for the front of the cooler. Here's a pic of the cut outs........... Attached image(s) 
|
   |
 
|
Posts in this topic
East coaster Oil cooler..........round two Feb 17 2006, 07:56 PM
East coaster other side.... Feb 17 2006, 07:57 PM East coaster I'm using two isolator mounts from these areas... Feb 17 2006, 08:00 PM East coaster Used a piece of billet aluminum and made a mountin... Feb 17 2006, 08:03 PM East coaster This is what it looks like fit up..... Feb 17 2006, 08:04 PM East coaster Once the mounting was squared away, it's on to... Feb 17 2006, 08:06 PM East coaster 20 minutes with a hacksaw blade and some 36 grit, ... Feb 17 2006, 08:07 PM East coaster I had to hot glue an additional chunk to this one ... Feb 17 2006, 08:10 PM Eric_Shea Slick! Feb 17 2006, 08:10 PM East coaster All shaping/fitting done and ready for disassembly... Feb 17 2006, 08:11 PM East coaster One mo' Feb 17 2006, 08:12 PM Eric_Shea Plans to lay a false floor on there? Feb 17 2006, 08:13 PM East coaster You guys bored of the pics yet?
The foam pieces a... Feb 17 2006, 08:15 PM East coaster Yeah.....I want to be able to put the factory fals... Feb 17 2006, 08:17 PM Eric_Shea Question/Concern:
With a GT shroud they made the ... Feb 17 2006, 08:17 PM GTPatrick Food for thought . http://www... Feb 17 2006, 08:23 PM East coaster I have about 35 % larger outlet than inlet. I woul... Feb 17 2006, 08:25 PM Dave_Darling 
