 suspension gurus, how low can you go? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DanT |
  Feb 28 2006, 08:35 PM
Post
#1
|
|
Going back to the Dark Side!  Group: Members Posts: 4,300 Joined: 4-October 04 From: Auburn, CA Member No.: 2,880 Region Association: None  |
Alright, there is a lot of information (misinformation) out there about how low you can set the suspension of your car.
how low is too low? how is the front geometry effected? should the A arms be sloping down(outward) level OK? how about sloping upward (outward) This is for aTRACK CAR and I want the car to be as low as possible without any idiosyncracies cropping up. I know about shock travel and bottoming out so what ya got? Right now I have the front suspension sloping downward (barely, maybe 2or 3 degrees) What is the word. (IMG:http://www.914world.com/bbs2/html/emoticons/dry.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/huh.gif) |
   |
 
|
Posts in this topic
Dan (Almaden Valley) suspension gurus Feb 28 2006, 08:35 PM
Joe Ricard 2 or 3 degrees is ALOT.
I strive for level A-arms.... Feb 28 2006, 09:23 PM r_towle with a stiff enough suspension, you can go so low ... Feb 28 2006, 09:33 PM J P Stein I think it's more tie rods than A arms.....but... Feb 28 2006, 10:10 PM nine14cats Hi Dan,
Check this thread out on roll center and ... Feb 28 2006, 10:23 PM brant Dan,
on my old car I used to run higher than my ... Feb 28 2006, 10:47 PM Dan (Almaden Valley) so I really want to look at the level of the tie r... Mar 1 2006, 12:43 AM
Jeroen if you lower the car to the point where the a-arms... Mar 1 2006, 06:27 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 06:14 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.