 Measuring Suspension Console replacement location, 'how to' for a novice... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| highways |
 Jul 22 2006, 08:55 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 613 Joined: 18-June 05 From: Los Angeles, CA Member No.: 4,296  |
So I need a little help to make sure I do this right. I've cut off my old damaged passenger side suspension console and I'm ready to weld in the new one. I've heard different things from 'it fits right into place' to 'measure from the center of the firewall'.
Being a novice at this operation... what measurements do I need to take? What mistakes should I look out for? I'm not a suspension geometry guru. Although I do know how to take accurate measurements if I know what to measure- but I don't know what to measure. I'm hoping it 'drops into place' without much room for error. Going to start welding today... advice needed! Thanks |
   |
 
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 11:50 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.