 Cylinder heads |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Blynes |
 Mar 3 2003, 06:26 PM
Post
#1
|
|
Member  Group: Members Posts: 68 Joined: 19-January 03 From: Savannah, GA Member No.: 169  |
I need a pair of cylinder heads for my 2.0 litre 914.
Can anyone help point me in the right direction? |
   |
 
|
  |
Replies
| Alfred |
Mar 5 2003, 02:58 PM
Post
#2
|
|
Unregistered |
Thanks JP.
I looked through my old textbooks and found the following information. "... Detonation can be caused by an excessively high compression ratio or by a low grade of gasoline. An overheated valve or bit of carbon, etc., can ignite the 'end gas' and cause the formation of the second flame front". "Preignition is caused when a glowing bit of carbon, an overheated spark plug, etc., ignites the fuel charge before the spark plug fires. When preignition occurs, the premature explosion attempts to drive the piston down against the direction of rotation". Alfred |
|
|
|
Posts in this topic
Blynes Cylinder heads Mar 3 2003, 06:26 PM
Brad Roberts Where are you located ??
I may have an extra set ... Mar 3 2003, 06:51 PM Dave Cawdrey Does that mean there are cracks elsewhere, B ? lo... Mar 3 2003, 10:41 PM Brad Roberts Typically 914 2.0 heads will be cracked around the... Mar 3 2003, 10:48 PM Alfred Dave Cawdrey Northwest Connecting Rod Service
1705 South 93rd ... Mar 4 2003, 01:21 AM Dave_Darling Man, those peen marks around the valve seats make ... Mar 4 2003, 02:08 AM Brad Roberts I have personally only seen your car twice and it ... Mar 5 2003, 02:27 AM Brad Roberts I was concerned with his peen marks also. Your beg... Mar 5 2003, 02:29 AM Dave Cawdrey Thats the way that "Race" guys does his staking. ... Mar 5 2003, 02:39 AM Brad Roberts My personal opinion: (which I happen to share freq... Mar 5 2003, 02:48 AM J P Stein IMO, a better way would be to use a center punch
a... Mar 5 2003, 03:08 AM Bleyseng Brad, Jerry is not a 'puter guy just a racer/m... Mar 5 2003, 09:36 AM Alfred I have a somewhat related question. After the loca... Mar 5 2003, 12:25 PM J P Stein As a general rule, your right, avoid sharp edges i... Mar 5 2003, 02:26 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 09:46 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.