 afm calibration, anyone know how to do it |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| bd1308 |
 Feb 11 2007, 03:00 AM
Post
#21
|
|
Sir Post-a-lot  Group: Members Posts: 8,020 Joined: 24-January 05 From: Louisville,KY Member No.: 3,501  |
man tuning that afm blindly is harder than my rust repair...
|
   |
 
|
| Bleyseng |
Feb 11 2007, 11:23 AM
Post
#22
|
|
Aircooled Baby! Group: Members Posts: 13,036 Joined: 27-December 02 From: Seattle, Washington (for now) Member No.: 24 Region Association: Pacific Northwest |
A mite lean I'd say
|
|
|
|
| jim_hoyland |
Feb 11 2007, 02:23 PM
Post
#23
|
|
Get that VIN ? Group: Members Posts: 9,885 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
|
Interestingly it doesn't run hot like it had before installing the rebuilt AFM. I'm still a little confused about the adjusting. I was looking at the picture of the AFM control mech posted previously and I'm unclear about what part you adjust. I was under the impression that the round black toothed doodah was moved; but the picture says to loosen the screw and move the arm---or did I read it wrong. Since I haven't does this before, it's all new.
And thanks for all the info, QUOTE(Bleyseng @ Feb 11 2007, 09:23 AM)  A mite lean I'd say |
|
|
|
| Bleyseng |
Feb 11 2007, 02:43 PM
Post
#24
|
|
Aircooled Baby! Group: Members Posts: 13,036 Joined: 27-December 02 From: Seattle, Washington (for now) Member No.: 24 Region Association: Pacific Northwest |
ok, check this out on adjusting the AFM arm.
Attached image(s) 
|
|
|
|
| jim_hoyland |
Feb 11 2007, 04:32 PM
Post
#25
|
|
Get that VIN ? Group: Members Posts: 9,885 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California
|
K-
Thanks. |
|
|
|
|
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th September 2025 - 04:40 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.