 CV joint assembly, writeup? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| yarin |
 Mar 8 2007, 08:07 AM
Post
#1
|
|
'14-X'in FOOL  Group: Members Posts: 988 Joined: 13-May 03 From: Guttenberg, NJ Member No.: 693 Region Association: North East States  |
Does anyone have a writeup on how to install a CV joint on the axle?
I'm uncertain of which goes first and in what direction. Here is a pic of the kit: (IMG:http://www.pmbperformance.com/i//CV_Joint_Kit.jpg) Thanks |
   |
 
|
Posts in this topic
yarin CV joint assembly Mar 8 2007, 08:07 AM
jr91472 huh...I just did this a few months back and could ... Mar 8 2007, 09:12 AM Joe Ricard How VW's this month has an article.
Pretty eas... Mar 8 2007, 09:19 AM yarin I removed both drive shafts already, that was a re... Mar 8 2007, 09:29 AM Joe Ricard New issue on the magazine rack at Wall mart yester... Mar 8 2007, 10:40 AM Cap'n Krusty Use whichever washer matches the one you took out,... Mar 8 2007, 11:44 AM
gopack
That kit doesn't appear to be for a 914, BTW.... Mar 8 2007, 11:50 AM
yarin
Use whichever washer matches the one you took out... Mar 8 2007, 05:13 PM Cap'n Krusty
Use whichever washer matches the one you took ou... Mar 9 2007, 12:12 PM yarin It's the right kit from PMB Performance.
http... Mar 8 2007, 12:20 PM Cap'n Krusty AHA! Generic picture. Don't forget to tr... Mar 8 2007, 02:16 PM Eric_Shea Kit comes with new washers ;) Mar 9 2007, 02:48 AM Eric_Shea Yarin,
I've created a CV joint installation m... Mar 9 2007, 11:03 AM Eric_Shea I think he's concerned that the PO didn't ... Mar 9 2007, 12:16 PM yarin
I think he's concerned that the PO didn't... Mar 9 2007, 07:30 PM yarin I started installed the CVs and ran into a few opt... Mar 10 2007, 09:38 AM johnlush Yarin,
The ones I have done had the concave washe... Mar 10 2007, 10:58 AM yarin
Yarin,
The ones I have done had the concave wash... Mar 10 2007, 11:49 AM 9146986 The last set I rebuilt required using a press to a... Mar 10 2007, 12:03 PM yarin
The last set I rebuilt required using a press to ... Mar 10 2007, 12:07 PM yarin Is this normal?
One CV joint moves freely.. the o... Mar 13 2007, 10:26 AM 1.8914 I'm at about the same stage you are in the pro... Mar 14 2007, 01:29 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 01:31 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.