 First run of '07! After setting valve geometry over the winte, Set the geometry IN THE CAR!!! Figured it out.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| jk76.914 |
 Apr 1 2007, 04:57 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 809 Joined: 12-April 05 From: Massachusetts Member No.: 3,925 Region Association: North East States  |
Woo Hoo!!!!
Just went for my first cruise of the year in my 914. Set the valve geometry over the winter with the engine in the car, and on jackstands only. I can hear the improvement!!! It was WAY OFF!! No special tools required!  What a treat. First time on the road since September, and it ran like a watch. Well worth the time and deep thought. Now, back to finishing up the body..... Priority for this year is the targa/windshield seal, and installation of the door glass. Think I can make it??? Jim |
   |
 
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th July 2025 - 03:35 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.