 rust repair, just wanted to make sure I'm not missing something |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| obscurity |
 Sep 29 2007, 04:25 PM
Post
#1
|
|
Member  Group: Members Posts: 411 Joined: 24-February 06 From: Atlanta ,GA Member No.: 5,628 Region Association: South East States  |
I am replacing the portion of the longitudinal in the engine compartment. I have painstakingly cut the replacement panel to fit (a little here and a little there) and when I have finally gotten the panel to sit more or less flush with the old metal on the inside face (see first pic below below) The flange on the back side is missing the wheel well panel by 1/4" (see further below) Is this just a simple case of "beat to fit, paint to match" or should it be a closer fit?
  Any help would be appreciated |
   |
 
|
Posts in this topic
obscurity rust repair Sep 29 2007, 04:25 PM
freezing14 you can have up to 1/8 inch gap between the panel... Sep 29 2007, 05:59 PM tracks914 :agree:
Start welding where the gap is small or c... Sep 29 2007, 06:06 PM tracks914 Is that photo from under the car looking up? Sep 29 2007, 06:07 PM
obscurity
Is that photo from under the car looking up?
n... Sep 29 2007, 06:12 PM tracks914 I still can't tell what I'm looking at but... Sep 29 2007, 06:18 PM obscurity
I still can't tell what I'm looking at bu... Sep 29 2007, 06:37 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 02:16 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.