 Options for sail panel trim, What is the best source for replacement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| PanelBilly |
 May 11 2008, 10:15 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,807 Joined: 23-July 06 From: Kent, Wa Member No.: 6,488 Region Association: Pacific Northwest 
 |
I'm very close to paint and I was looking at the aluminum trim for the sail panels. They have dents and are warped. So who has purchased replacement parts and did they fit properly?
I'm not going to put vinyl back on and the little holes for the trim strip that finishes the bottm of the vinyl has been filled in, so I'm only concerned about the two parts that fun down the back and rear sides of the sails and the peice that runs along the top of the roll bar. Or should I just take my time and repair the parts I have already? billy |
   |
 
|
Posts in this topic
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 07:46 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.