 Plastic pieces at the base of the carb manifolds on a 6, What goes with them? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| PeeGreen 914 |
 May 1 2009, 03:45 AM
Post
#1
|
|
Just when you think you're done...wait, there is more..lol  Group: Members Posts: 10,219 Joined: 21-September 06 From: Seattle, WA... actually Everett Member No.: 6,884 Region Association: Pacific Northwest 
 |
So I am putting the last few pieces on my engine before it goes back in and I have the plastic pieces that go under the manifolds. Just curious what the preffered is to do with them. do they go on bare? Do you use gaskets? Do you use Toyota black? What should I use? (IMG:style_emoticons/default/beerchug.gif)
|
   |
 
|
| Gint |
May 1 2009, 06:36 AM
Post
#2
|
|
Mike Ginter Group: Admin Posts: 16,071 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains  |
Gasket goes on each side of the insulator. I don't use any sealer (my manifolds are flat).
|
|
|
|
| PeeGreen 914 |
May 1 2009, 11:29 AM
Post
#3
|
|
Just when you think you're done...wait, there is more..lol Group: Members Posts: 10,219 Joined: 21-September 06 From: Seattle, WA... actually Everett Member No.: 6,884 Region Association: Pacific Northwest
|
I thought that was what went on there but I didn't have any in my rebuild set (IMG:style_emoticons/default/dry.gif) Well, time to order them up (IMG:style_emoticons/default/smile.gif) Thanks Gint (IMG:style_emoticons/default/beerchug.gif)
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th May 2024 - 02:12 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.