 FS: 1973 1.7 project, $700 obo |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
| MrZir |
 Jul 15 2009, 10:37 AM
Post
#1
|
|
Newbie  Group: Members Posts: 20 Joined: 11-May 07 From: Fort Worth, TX Member No.: 7,731 Region Association: South East States  |
This project car is in pieces, most of which are in boxes. It has all of the main parts except for the front windshield. It was running when it was torn down, but I have tossed the plastic fuel lines and several small rubber pieces that were in poor condition.
The front and rear turn signals have broken/missing lenses, but the buckets are servicable. The PO replaced part of the floor pan, but it may need to be cleaned up/redone. The longs are in fairly good shape, but the hell hole is below average. The engine has a single carb and it has a sideshift transmission. It also has a 19mm master brake cylinder, in used condition. Tires were bought new, never used, but are a few years old now. Car is located in west Fort Worth, TX 76108 and will need to be towed. Clear title. Thanks for looking! Car  floor  right long  left long  spot of rust around driver's door  engine  trunk with stock muffler, floor cross-member pieces  Attached image(s) 
|
   |
 
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 04:31 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.