 Brake Cable Routing, How to? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 19144jt |
 Aug 3 2009, 01:03 PM
Post
#1
|
|
Member  Group: Members Posts: 176 Joined: 19-September 05 From: Grass Valley, CA Member No.: 4,829  |
Hi Guys,
Went to replace the parking brake cables on my 1975 and found that the old ones (seized) were routed up over the top of the heat exchangers. This didn't seem right to me for a couple reasons: this causes a somewhat sharp bend from where it exits the top of the heat exchanger to where goes through it's mount and is clipped on and it has to touch the exchanger so I would assume it could get pretty hot (not too good for a cable). Neither my factory nor aftermarket manuals have the cable routing in them. Can anybody tell me what is correct here? John |
   |
 
|
Posts in this topic
19144jt Brake Cable Routing Aug 3 2009, 01:03 PM
McMark Route them above the engine mount bar, but below t... Aug 3 2009, 10:09 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 09:03 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.