pete
Sep 14 2010, 02:05 PM
I need to weld up a low, rolling engine stand for my SBC350 and transaxle. I want to be able to roll it right under my car. Anyone out there have some pics of theirs?
Andyrew
Sep 14 2010, 02:26 PM
Strong furnature dolly's work. I use the large one, then get wood and nail it to the furnature dolly so that the engine is level. This allows you to get a low profile jack under it if necessary. Oh and have the front motor mount already on the engine, not sure if that was obvious..)
Good luck!