The rust IS bad....so, got me a new "nibbler" and started cutting the floors out. I will be tig welding in tubes from the rear torsion forward to the front to give it more support......16 gauge sheet metal will go into the floors.

Flares WILL be molded in and the 2.2/6 will be installed as soon as that is done.
Floors.....:eek: [img]
More....

UPDATE on "Manfred"....oil tank is in, plumbing is 75% done.....will be finishing oil lines tomorrow or the next day and then do some trial fitting of the engine and trans.....

Lot of work going on at your place!