I'm looking for the upholstered interior back pad that fits a car with adjustable seats. It must be black, no breaks/cracks at the harness inertia reels, no cuts, punctures or water damage.
I will also buy just the back pad board if you have one in good condition (all four clips intact, etc.)...
I also need the engine compartment harness (12-pin connector at relay board to heater blower, back up switch, starter solenoid, etc.) for the same car ('74 1.8 USA model). I HAVE FOUND ONE OF THESE, WILL POST CONDITION UPON RECEIPT!
Pete Zimmermann
Full Version: WTB For '74 1.8
QUOTE(Peter Zimmermann @ Oct 25 2010, 08:52 AM) 
I'm looking for the upholstered interior firewall pad that fits a car with adjustable seats. It must be black, no breaks/cracks at the harness inertia reels, no cuts, punctures or water damage.
I also need the engine compartment harness for the same car ('74 1.8 USA model).
Pete Zimmermann
Do you mean the FI , ignition harness or both for a 74 1.8L ?
QUOTE(rdauenhauer @ Oct 25 2010, 02:51 PM)
QUOTE(Peter Zimmermann @ Oct 25 2010, 08:52 AM)
I'm looking for the upholstered interior firewall pad that fits a car with adjustable seats. It must be black, no breaks/cracks at the harness inertia reels, no cuts, punctures or water damage.
I also need the engine compartment harness for the same car ('74 1.8 USA model).
Pete Zimmermann
Do you mean the FI , ignition harness or both for a 74 1.8L ?
The harness that connects to the relay board with a 12-pin connector...but I found one.
Sill looking for a nice back pad complete with board!
QUOTE(Peter Zimmermann @ Nov 8 2010, 02:41 PM)
QUOTE(rdauenhauer @ Oct 25 2010, 02:51 PM)
QUOTE(Peter Zimmermann @ Oct 25 2010, 08:52 AM)
I'm looking for the upholstered interior firewall pad that fits a car with adjustable seats. It must be black, no breaks/cracks at the harness inertia reels, no cuts, punctures or water damage.
I also need the engine compartment harness for the same car ('74 1.8 USA model).
Pete Zimmermann
Do you mean the FI , ignition harness or both for a 74 1.8L ?
The harness that connects to the relay board with a 12-pin connector...but I found one.
Sill looking for a nice back pad complete with board!
Rec'd my harness today, it's definitely enough to work with, I'll have to add some shrink tube here and there, and put new W-crimp connectors in a few places (coil and starter solenoid), but it was well-described by the seller and will save me many hours trying to figure out just what the heck a PO thought he was doing!
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.